Citation

Cho YB, Bae CH, Suh MW, Sin HC. Int. J. Veh. Des. 2008; 46(1): 23-50.

Copyright

(Copyright © 2008, Inderscience Publishers)

DOI

10.1504/IJVD.2008.017068

PMID

unavailable

Abstract

The crash energy absorption for frontal impact of a vehicle front frame has unsymmetrical shape due to the design layout constraints of the engine room was maximised to change bending mode to axial crush mode using simple crash trigger. The proper location decision of crash trigger induced axial crushing were applied the homogenisation method. The low strained elements became the hole-type crash trigger. The effective optimum sizes of crash trigger were studied according to impact velocity, ratio of thickness to width (t/b) and aspect ratio (a/b) of frame. The optimisation results of the dynamic crushing load were compared with those from the theoretical equations.