Citation

Yoganandan N, Humm JR, Pintar FA, Maiman DJ. Med. Eng. Phys. 2013; 35(8): 1181-1187.

Affiliation

Department of Neurosurgery, Medical College of Wisconsin, Milwaukee, WI 53226, USA. Electronic address: yoga@mcw.edu.

Copyright

(Copyright © 2013, Institute of Physics and Engineering in Medicine, Publisher Elsevier Publishing)

DOI

10.1016/j.medengphy.2012.12.012

PMID

23357337

Abstract

To understand the biomechanics of the human body in motor vehicle environments, physical models including anthropomorphic test devices (ATD) and biological models (postmortem human surrogates) are used, and sled tests are conducted. Deflection is often used as a biomechanical variable to characterize the effects of impact loading and derive injury criteria. The objective of the present study was to evaluate different techniques and recommend a methodology to determine the peak thorax and abdominal deflections from temporal contours using chestbands in oblique lateral impacts. The side impact ATD WorldSID representing human surrogates was positioned on a seat. The seat was rigidly fixed to the platform of an acceleration sled. The oblique load-wall fixed to the sled consisted of separate and adjustable plates to contact the shoulder, thorax, abdomen, and pelvis. Two 59-gage chestbands were wrapped on the thorax and abdomen. Tests were conducted at low, medium, and high velocities (3.4, 6.7, and 7.5m/s) and three methods, termed the spine-sternum, bilateral, and spine-box, were used to determine the global peak deflection and its angulation. Results indicated that all three methods produced very similar angulations, for all velocity tests, and at both thorax and abdominal regions. However, maximum deflections were the lowest in the spine-sternum, followed by bilateral and spine-box methods, with one exception. Based on the development of deflection contours, locations used in the definitions of the origin, and accuracy in identifying critical locations/points in time-varying contours, results of the present study indicate that the bilateral method is the optimum procedure to determine the oblique peak deflection vector in biomechanical tests.

Language: en