Citation

Beeman SM, Kemper AR, Madigan ML, Duma SM. Accid. Anal. Prev. 2013; 55: 34-47.

Affiliation

Virginia Tech - Wake Forest University, School of Biomedical Engineering and Sciences, Center for Injury Biomechanics, 325 Stanger St. (MC 0194), Blacksburg, VA 24061, USA.

Copyright

(Copyright © 2013, Elsevier Publishing)

DOI

10.1016/j.aap.2013.02.015

PMID

23507433

Abstract

Despite improvements in vehicle design and safety technologies, frontal automotive collisions continue to result in a substantial number of injuries and fatalities each year. Although a considerable amount of research has been performed on PMHSs and ATDs, matched dynamic whole-body frontal testing with PMHSs and the current ATD aimed at quantifying both kinetic and kinematic data in a single controlled study is lacking in the literature. Therefore, a total of 4 dynamic matched frontal sled tests were performed with three male PMHSs and a Hybrid III 50th percentile male ATD (28.6g, Δv=40kph). Each subject was restrained using a 4kN load limiting, driver-side, 3-point seatbelt. Belt force was measured for the lap belt and shoulder belt. Reaction forces were measured at the seat pan, seat back, independent foot plates, and steering column. Linear head acceleration, angular head acceleration, and pelvic acceleration were measured for all subjects. Acceleration of C7, T7, T12, both femurs, and both tibias were also measured for the PMHSs. A Vicon motion analysis system, consisting of 12 MX-T20 2 megapixel cameras, was used to quantify subject 3D motion (±1mm) at a rate of 1kHz. Excursions of select anatomical regions were normalized to their respective initial positions and compared by test condition and between subject types. Notable discrepancies were observed in the responses of the PMHSs and the ATD. The reaction forces and belt loading for the ATD, particularly foot plate, seat back, steering column, and lap belt forces, were not in agreement with those of the PMHSs. The forward excursions of the ATD were consistently within those of the PMHSs with the exception of the left upper extremity. This could potentially be due to the known limitations of the Hybrid III ATD shoulder and chest. The results presented herein demonstrate that there are some limitations to the current Hybrid III ATD under the loading conditions evaluated in the current study. Overall, this study presents a comprehensive data set of belt forces, reaction forces, accelerations, and bilateral displacement data that can be used to evaluate the performance of ATDs and validate computational models.

Language: en