Citation

Harifi A, Aghagolzadeh A, Alizadeh G, Sadeghi M. Transp. Res. C Emerg. Technol. 2008; 16(6): 731-741.

Copyright

(Copyright © 2008, Elsevier Publishing)

DOI

10.1016/j.trc.2008.02.003

PMID

unavailable

Abstract

Antilock brake system (ABS) has been designed to achieve maximum negative acceleration by preventing the wheels from locking. Research shows that the friction between road and tire is a nonlinear function of wheel slip. Therefore, maximum negative acceleration can be achieved by designing a suitable control system for wheel slip regulation at its optimum value. Since there is a lot of nonlinearity and uncertainty (uncertainty in mass and center of gravity of the vehicle and road condition) in vehicle dynamics, a robust control method should be used. In this research, a sliding mode controller for wheel slip control has been designed based on a two-axle vehicle model. Important considered parameters for vehicle dynamic include two separated brake torques for front and rear wheels as well as longitudinal weight transfer caused by the acceleration or deceleration. One of the common problems in sliding mode control is chattering phenomenon. In this paper, primary controller design has been improved using integral switching surface to reduce chattering effects. Simulation results show the success of integral switching surface in elimination of chattering side effects and by high performance of this controller. At the end, the performance of the designed controller has been compared with three of the prevalent papers results to determine the performance of sliding mode control integrated with integral switching surface.

Language: en