Citation

Kumar A, Bhaskar G, Singh JK. Appl. Ergon. 2009; 40(1): 91-102.

Affiliation

Division of Agricultural Engineering, Indian Agricultural Research Institute, New Delhi 110012, India. adarsh_iari@rediffmail.com

Copyright

(Copyright © 2009, Elsevier Publishing)

DOI

10.1016/j.apergo.2008.01.017

PMID

18339354

Abstract

Tractors in low-income countries are used both for farm and non-farm activities. Most of the tractors being manufactured in India are products of collaboration with other countries. The design of tractors manufactured in India has not changed much in the past five decades especially from an ergonomics point of view, because of economic considerations. This paper describes a tractor control layout assessment with respect to the Indian population and compares the location of controls with workspace envelopes and the IS12343 standard for commonly used tractors on Indian farms. Controls like steering, foot clutch, foot brake, foot accelerator are located in areas defined by IS12343 standard in some tractors but these are not placed in the workspace envelopes of the Indian population. This results in a mismatch between the workspace envelope and location of controls as defined by the standard. The controls need a complete change in their layout to be in the workspace envelopes, as this cannot be achieved by providing seat movement in the horizontal and vertical directions in the present tractor design.

Language: en