Citation

Martin JS, Larson GD, Scott J. J. Acoust. Soc. Am. 2006; 120(5): 2676-2685.

Affiliation

School of Mechanical Engineering, Georgia Institute of Technology, Atlanta, GA 30332-0405, United States

Copyright

(Copyright © 2006, American Institute of Physics)

DOI

unavailable

PMID

unavailable

Abstract

Techniques have been studied for the detection of buried landmines with acoustic/seismic interrogation signals. Much of this work has involved full wave-field imaging from local measurements of ground motion using noncontact sensors. These offer inherent safety for the system operator and accommodate the need to make measurements over rough ground surfaces. The system requirement is, however, only that a sensor does not intrude on the measurement rather than that it not contact the ground. An experimental investigation was conducted into the feasibility of an array of ground-contacting sensors for use in a seismic landmine-detection system that exploits full wave-field imaging. The main considerations in the design of the array sensor were safety, sensitivity, fidelity, reproducibility, and sensor-to-sensor interaction. A relatively simple and inexpensive sensor was demonstrated in an experimental simulation of a landmine-detection system. The sensor, which is suitable for inclusion in a large planar array that could be used for detection confirmation, exerts a safe normal force at the point of contact and enables detection performance comparable to that which could be achieved using noncontact techniques.