@article{ref1,
title="Fire detection, location and heat release rate through inverse problem solution. part ii: experiment",
journal="Fire safety journal",
year="1997",
author="Richards, RF and Ribail, RT and Bakkom, AW and Plumb, OA",
volume="28",
number="4",
pages="351-378",
abstract="The design and fabrication of a prototype video fire detection system, which can locate a fire and determine its heat release rate, is described. The operation of the prototype system is demonstrated in a series of small-scale tests. The system utilizes a video camera to monitor an array of passive sensors distributed around the compartment to be protected. Each of the sensors is made up of a temperature-sensitive sheet that changes color at a prescribed temperature. In the event of an accidental fire, the plume of hot combustion gases rising from the fire will cause the temperature-sensitive sensors to be activated and change color. The times and locations of sensors changing color are used as data for an inverse problem solution algorithm, which determines the location and the heat release rate of the fire. A small-scale evaluation of the prototype video system is presented in which the prototype system is used to detect, locate and determine the heat release rate of a 2[middle dot]4 kW burner placed in a 2[middle dot]75 m wide by 2[middle dot]75 m deep by 1[middle dot]5 m high test enclosure. The accuracy of the prototype system in locating and determining the heat release rate of the small flame source placed in the reduced-scale enclosure is reported. In addition, the ability of the prototype system to make approximate measurements of the optical thickness of smoke in the enclosure, along camera-sensor lines-of-sight and then to use these measurements to locate and track the growth of a smoke plume is demonstrated.<p />",
language="",
issn="0379-7112",
doi="",
url="http://dx.doi.org/"
}