TY  - JOUR
PY  - 2019//
TI  - Experimental studies on characteristics of fire whirl in a vertical shaft
JO  - Fire and materials
A1  - Gao, Zheming
A1  - Li, Shusheng
A1  - Gao, Ye
A1  - Chow, Wan Ki
SP  - 229
EP  - 240
VL  - 43
IS  - 3
N2  - An internal fire whirl can be generated readily in a tall shaft model with appropriate gap width at one corner. Experimental study was carried out to investigate the relationship between the characteristics of an IFW and the corner gap width in a 9-m-tall vertical shaft model. The vertical shaft had a 2.1 m by 2.1 m square section with gasoline pool fire of different diameters burning inside. The gap width was varied to investigate its impact on fire whirl characteristics, such as flame development, swirling intensity, flame height, flame temperature, and heat release rate of the gasoline pool fire. Vigorous flame swirling motions were generated when the ratio of the gap width to the shaft section perimeter was within the range 0.16 to 0.21. From the flame streamline angle, it was observed that the swirling component was much stronger than buoyancy component near the bottom of burning region. The swirling component decreased and became roughly the same as buoyancy near the middle. Finally, it diminished to being much weaker than buoyancy near the top of the fire. These observations suggest that the Froude number Fr decreased from a large number to 1, and then continued to decrease to 0.<p />  <p>Language: en</p>
LA  - en
SN  - 0308-0501
UR  - http://dx.doi.org/10.1002/fam.2691
ID  - ref1
ER  -