Citation

Scott SH, Winter DA. J. Biomech. 1993; 26(9): 1091-1104.

Affiliation

Department of Systems Design Engineering, University of Waterloo, Ontario, Canada.

Copyright

(Copyright © 1993, Elsevier Publishing)

DOI

unavailable

PMID

8408091

Abstract

A model of the human foot is proposed in which the foot is represented as eight rigid segments and eight monocentric, single-degree-of-freedom joints. The soft tissue under the foot is divided into seven independent sites of contact, or loading, and each of these is modelled as a nonlinear spring and a nonlinear damper in-parallel. The model was used to estimate the kinematics and kinetics of the foot during the stance phase of walking. The force sustained at each loading site was calculated from walking trials in which only portions of the foot landed on a small force platform. The position of the calcaneus was defined by surface markers, whereas the position of the distal segments were based upon chalk footprints and an estimate of the compression of the plantar soft tissue. The results suggest that the joints that constitute the longitudinal arch extend slightly when the forefoot is loaded. During push-off, these joints flex as the metatarsophalangeal joints extend. Similar kinematic results were estimated when the distal segments of the foot were defined by surface markers. The magnitude of the joint moments of force depended largely on the distribution of the load under the foot which varied considerably between subjects. The stable, yet resilient properties of the foot, as highlighted by this model, should be considered in three-dimensional dynamic models used to study human locomotion. The model provides an objective tool to quantify foot motion and loading, which may prove useful for describing foot function in normal and pathological conditions.

Language: en