Citation

Yang JK, Wittek A, Kajzer J. Proc. IRCOBI 1997; 24: 377-388.

Copyright

(Copyright © 1997, International Research Council on Biomechanics of Injury)

DOI

unavailable

PMID

unavailable

Abstract

This paper presents a finite element model (FEM) of the human lower extremity skeleton system to facilitate the investigation of dynamic responses of the lower extremity to lateral impact loading. The model consists of the femur, the tibia, and the knee ligaments. The geometry and mass distribution of the model were chosen to represent a 50th percentile male lower extremity skeletal structure. Boundary conditions were defined in accordance with the configuration of a car-pedestrian lateral collision. The model was implemented by means of the DYNA3D FE program. The tibia segment of the model was validated against the published three-point bending test with human leg specimens. The whole model was validated against previously performed tests with lower extremity specimens at impact speeds of 30 and 17 km/h. A stress analysis was performed in terms of the injury mechanism of the lower extremity to a lateral impact loading. The calculated peak tensile stress in the model at impact speed of 30 km/h is 160 MPa which corresponds to the stress level of failure of the tibia. At impact speed of 17 km/h the peak tensile stress is 102 MPa that is lower than the ultimate tensile stress of the tibia. The model facilitates the calculation of detailed physical quantities such as stress distribution within simulated structures, and contributes to a better understanding of injury mechanisms at the level of stress analysis.