CONTACT US: Contact info
|
Citation |
Chumbley S, Zhang S, Morris M, Spotts R, Macziewski C. J. Forensic Sci. 2016; 62(1): 83-91. |
|
Affiliation |
Ames Laboratory, Iowa State University, 2220 Hoover, Ames, IA, 50011. |
|
Copyright |
(Copyright © 2016, American Society for Testing and Materials, Publisher John Wiley and Sons) |
|
DOI |
|
PMID |
27864946 |
|
Abstract |
Since the development of the striagraph, various attempts have been made to enhance forensic investigation through the use of measuring and imaging equipment. This study describes the development of a prototype system employing an easy-to-use software interface designed to provide forensic examiners with the ability to measure topography of a toolmarked surface and then conduct various comparisons using a statistical algorithm. Acquisition of the data is carried out using a portable 3D optical profilometer, and comparison of the resulting data files is made using software named "MANTIS" (Mark and Tool Inspection Suite). The system has been tested on laboratory-produced markings that include fully striated marks (e.g., screwdriver markings), quasistriated markings produced by shear-cut pliers, impression marks left by chisels, rifling marks on bullets, and cut marks produced by knives. Using the system, an examiner has the potential to (i) visually compare two toolmarked surfaces in a manner similar to a comparison microscope and (ii) use the quantitative information embedded within the acquired data to obtain an objective statistical comparison of the data files. This study shows that, based on the results from laboratory samples, the system has great potential for aiding examiners in conducting comparisons of toolmarks. Language: en |