Citation

Encarnación-Martínez A, García-Gallart A, Gallardo AM, Sánchez-Sáez JA, Sánchez-Sánchez J. Sports Biomech. 2018; 17(2): 251-260.

Affiliation

Faculty of Physical Activity and Sports Sciences, Department of Sports Science and Physical Activity , Catholic University of Murcia , Murcia , Spain.

Copyright

(Copyright © 2018, Edinburgh University Press)

DOI

10.1080/14763141.2017.1285347

PMID

28632048

Abstract

The third generation of artificial turf systems (ATS) has matched the mechanical behaviour of natural grass, but today a high heterogeneity at structural level and mechanical behaviour in the new ATS also exists. The objective was to analyse the effect of the structural components of ATS football pitches and running speed on the capacity of impact attenuation. A total of 12 athletes were evaluated at three speed conditions (3.33 m/s, 4 m/s and maximum speed) on four different ATS, classifying them by their components (length of fibre, type of in-fill and sub-base). Impact attenuation was significantly higher in ATS3, characterised by longer fibre compared to other ATS with less fibre length. The ATS4 with a higher length fibre and built on compacted granular material proportioned significantly lower values in the maximum peaks of tibia acceleration. Finally, as speed increases, the peak tibia impacts were significantly higher. Longer fibre length and the capacity to accommodate a higher quantity of infill facilitate higher impact attenuation. Equally, a compacted granular sub-base is related to lower magnitude of maximum tibia peaks. Finally, the magnitude of the tibia acceleration peaks is dependent of running speed for all ATS analysed, being higher as speed increases.

Keywords: Soccer;

Language: en

Keywords

Artificial grass; biomechanics; impact attenuation; mechanical properties