Citation

Tian C, Zhai G, Gao Y, Chen C, Zhou J. Sensors (Basel) 2023; 23(4): e1792.

Copyright

(Copyright © 2023, MDPI: Multidisciplinary Digital Publishing Institute)

DOI

10.3390/s23041792

PMID

36850390

PMCID

PMC9965079

Abstract

Aiming at the problem of low control accuracy caused by nonlinear disturbances in the operation of the PLS-160 wheel-rail adhesion test rig, a linear active disturbance rejection controller (LADRC) suitable for the wheel-rail adhesion test rig was designed. The influence of nonlinear disturbances during the operation of the test rig on the control accuracy was analyzed based on SIMPACK. The SIMAT co-simulation platform was established to verify the control performance of the LADRC designed in this paper. The simulation results show that the speed and creepage errors of the test rig under the control of the LADRC met the adhesion test technical indicators under four different conditions. Compared with the traditional PID controller, the creepage overshoot and response time with the LADRC were reduced by 1.27% and 60%, respectively, under the constant creepage condition, and the stability recovery time was shorter under the condition of a sudden decrease in the adhesion coefficient. The LADRC designed in this paper shows better dynamic and anti-interference performance; therefore, it is more suitable for a follow-up study of the PLS-160 wheel-rail adhesion test rig.

Language: en

Keywords

co-simulation; creepage control; linear active disturbance rejection controller; nonlinear disturbance; PLS-160 wheel–rail adhesion test rig