Citation

Hasegawa A, Egawa Y, Nisida T, Kishida K, Fujimura Y, Takeuchi R, Yamada H, Fujii T, Saito Y. Traffic Injury Prev. 2023; 24(Suppl 1): S68-S74.

Copyright

(Copyright © 2023, Informa - Taylor and Francis Group)

DOI

10.1080/15389588.2022.2136944

PMID

37267017

Abstract

OBJECTIVE: In this research, body technology was established for side collisions with new IIHS MDB as a representative case. In the conventional body structure, most of the load received from the barrier is absorbed by bending deformation of the door beam and B-pillar, etc. For that reason, the body is subjected to large deformation before reaching the maximum load, and the deformation increases further when subjected to a high-energy collision. Therefore, the objective of this research is to create a structure that increases the load from the initiation of impact and suppresses the deformation of the car body.

METHOD: An arched door beam was developed to reduce the bending moment by the axial load in the longitudinal direction generated during the deformation and to increase the load in the lateral direction. A principle equation was developed that uses the shape of the door beam as a variable. A prototype of the arched door beam was fabricated, and its performance was evaluated by an impactor test. A full-car simulation was conducted using a mass-produced sedan as a base, to which the arched door beam was added to verify the performance of the complete vehicle.

RESULTS: The results of the impactor tests were evaluated using the load gradient, which was defined as the generated load divided by the amount of deformation. Compared to conventional straight door beams, the load gradient was 7.1 times higher. Full-car simulation results showed that for a gasoline-powered vehicle body weight, the body load gradient of the proposed structure was 4.7 times higher, and the body deformation adjacent to the dummy shoulder was reduced by 210 mm. Spine acceleration of the dummy was reduced by 56%.

CONCLUSION: The body structure proposed in this research has the effect of increasing the load gradient and reducing body deformation and spine acceleration. It is expected to be applicable to EVs and FCVs, which require more energy absorption due to their increased vehicle weight.

Language: en

Keywords

deformation; door beam; IIHS MDB; load gradient; side collision; spine acceleration