Citation

Kapoor T, Altenhof W, Howard AW, Rasico J, Zhu F. Accid. Anal. Prev. 2008; 40(6): 1880-1892.

Affiliation

Department of Mechanical, Automotive and Materials Engineering, University of Windsor, 410 Sunset Avenue, Windsor, Ontario, Canada N9B 3P4.

Copyright

(Copyright © 2008, Elsevier Publishing)

DOI

10.1016/j.aap.2008.07.008

PMID

19068290

Abstract

This research focuses on the injury potential of children seated in forward-facing child safety seats during side impact crashes in a near-side seated position. Side impact dynamic sled tests were conducted by NHTSA at Transportation Research Center Inc. (TRC) using a Hybrid III 3-year-old child dummy seated in a convertible forward/rearward child safety seat. The seat was equipped with a LATCH and a top tether and the dummy was positioned in forward-facing/near-side configuration. The test was completed using an acceleration pulse with a closing speed of 24.1km/h, in the presence of a rigid wall and absence of a vehicle body. A fully deformable finite element model of a child restraint seat, for side impact crash investigations, has been developed which has also been previously validated for frontal and far side impacts. A numerical model utilizing a Hybrid III 3-year-old dummy, employing a similar set-up as the experimental sled test was generated and simulated using LS DYNA. The numerical model was validated by comparing the head and the chest accelerations, resultant upper and lower neck forces and moments from the experimental and numerical tests. The simulation results were observed to be in good agreement to the experimental observations. A numerical model of the near-side laboratory tests, utilizing a Q3s child dummy, was also created for parametric studies regarding different ISOFIX configurations. Further, numerical simulations were completed for both the dummy models with rectangular and cross-shaped sections of rigid ISOFIX systems. In addition, studies were conducted to confine lateral movement of the dummy's head by adding energy absorbing foam on the side wings in the vicinity of the contact region of the CRS. It was observed that the use of rigid ISOFIX system reduced the lateral displacement of the CRS and different injury parameters. Addition of energy absorbing foam blocks was effective in further reducing the lateral displacement of the dummy's head. The lateral displacement of the head was reduced by 68mm by using cross-shaped section ISOFIX with energy absorbing foam near the vicinity of the head of the Hybrid III 3-year-old dummy compared to the flexible LATCH configuration without foam. For the Q3s dummy, the lateral displacement of the head was reduced by 48mm by utilizing a cross-shaped section rigid ISOFIX system with the addition of energy absorbing foam compared to the flexible LATCH configuration.

Language: en